Answer Posted / gopalakrishna
no it i'll not effected on rain & clouds why because this
is not a distroyer and it i'll not pollutant.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Why 1/3 is used in symmetrical components?
what is meant by flywheel and its role in retardation test
what is the purpose of silicon dropper used in battery charger?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
Explain the purpose of inductor in an electric circuit?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
whatis the commertial spec. of distribution boards ?
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.