Interested to Buy Any Domain ? << Click Here >> for more details...
what are level of automation & how these are distinguished ?
- 3 Answers
- 5742 Views
- I also Faced
- E-Mail Answers
Answer Posted / lyogendra kumar mishra
Level 0:field control system done by field devices motor, sensors
LEVEL 1: PROCESS CONTROL SYSTEM, WITH HELP FROM DCS, PLC
LEVEL 2: PROCESS OPTIMIZATION SYSTEM ACHIEVED BY ALOGRITHMS AND MATHEMATICAL MODELS
LEVEL 3: RESOURCE OPTIMIZATION SYSTEM MES, SAP
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calibration a control valve?
How we connect a instrument with ground, Give brief explanation with help of diagram?
What is Positive Calibration and Negative Calibration?
what is the diffrence between pressure safety valve & pressure relief valve....pls
draw the block diagram of a level transmitter ?
can we copy the software from a transmitter using hht(hart 275) ?
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
What is cut off relay? And why use in PLC and DCS?
Why even multiple power supplu r used in instrumentation system?
What is Predictive Maintenance
i want to find out iffco get test paper
How to Calibrate Vortex Flow transmitter in field
