why u want to work in sail/ntpc as u r already in an it
company where life is good, good environment no much
tensions etc?
- 6 Answers
- 13204 Views
- Sail, I also Faced
- E-Mail Answers
Answer Posted / guest
NO Comparision any psu/navratan/maharatan/govt is far
better than any it company/software job in respect of
1) salary
2) job security
3) provide respectable position for an engineer
4) good work profile especially for civil,mech and
electrical
5)give u much oppertunity to apply your core technical
skill
| Is This Answer Correct ? | 17 Yes | 5 No |
Post New Answer View All Answers
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
what is the control circuit for operating the clean room air shower
Transmission through a short line depends on
What is the equivalent circuit of a transformer and its vector diagram?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
For overhead protection we use which transformer?
What are the factors which influence the choice of specific magnetic and electric loadings of a synchronous machine?
What is difference between Sample test and Routine test in safety standard?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
Why can't we parallel the secondary circuits of two voltage transformers?
