Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if LV supply is fed to a HT motor?
- 19 Answers
- 47431 Views
- ITC Infotech, Jindal, I also Faced
- E-Mail Answers
Answer Posted / sameer vijayakar
motor will pick up the full speed slowl as the motor runs
on low torque and the inertia helps in pcking up speed as
the torque is consistently applied.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the limitations of Kirchoff's laws?
What is meant by cold loop test in instrument
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
What is the suitable transmission voltage?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
How to calculate earth wire load by formula
I Want randstand placement papers
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
what is the question paper model for section engineer in RRB
What are the differences between single phase and three phase?
What is current & voltage ? Voltage perform at any load without current or not?
power transmission pole used one support , that only for support or earthing
why ahould you show client/engineer activities clearly on the project plan
