Interested to Buy Any Domain ? << Click Here >> for more details...
In 400KV Switchyard, we have used Circuit Breaker With PIR,
what is the significance of PIR & why they'r used?
- 2 Answers
- 20536 Views
- I also Faced
- E-Mail Answers
Answer Posted / t r sastry
PIR - Pre-insertion resistor
PIR is used for safe handling of the transients in EHV
switching operations. PIR will be active only for few milli
seconds during switching after which it will be out of
circuit
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
what is the isolation transformer. what is the isolator?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
What is the complete procedure of erection of electrical panel in industry
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Why neutral point is consider as zero potential?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
how many stairs have you climbed while you were coming
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
how maney type tempereture measurement ?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
What is the function of under voltage release ?
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
