Interested to Buy Any Domain ? << Click Here >> for more details...
why we do not switched on capicitor panel with DG Supply
- 3 Answers
- 6143 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / arvind kumar
DG sets are used to supply local loads and as per designing
of DG the power factor is consider 0.8, hence in this case
capacitor bank may not required.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
what is the range of maximum DOL and SDS can be use for pump and fan application
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is meant by turbo alternators?
What is order of the system?
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
The height to which the liquid in a tank to be maintained for a certain constant velocity?
i've iocl interview.. if you know the interview process please give me information..
Single phase and threephase power calculation
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
What cmos is and its benefits?
