75kw drive operated motor current fluctuation
from(85-130)ampere.current setting in drive
is 130amp.sometimes motor trip when current
limit cross 130amps.I change the drive. still
current fluctuate between 80-130amps but in
this time motor not trip,current setting in
drive is 130amps.where is the problem?
- 1 Answers
- 3115 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohit punjabi
the motor will not trip because as the user has change an old drive which was of 75 kw with new one so he has to set a parameter in new drive that when fluctated above 130 amps the drive should trip the motor without these parameter setting the new drive will not trip
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is dielectric loss?
What is the maximum and minimum rating of UPS?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
what is under coal gassification?
What is referred to the electron in the outer orbit?
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
what is the difference between 2 way and 4 pole selector switch???
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
State ohm’s law?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
how calculate the electrical load for industry and office
why ten delta testing is carried out on power transformer
