Interested to Buy Any Domain ? << Click Here >> for more details...
What is the detail function of I/O card in DCS ? Why we
dont use the I/O directly with controller?
- 3 Answers
- 15889 Views
- Kekran Mekran, TCE, I also Faced
- E-Mail Answers
Answer Posted / delta_v
Remember that from field instruments the signal sent are only process data (example temperature, pressure); these data can't be read by the controller, hence it will become useless.
That is why IO cards are used to convert these to a readable signal which is 4-20mA.
"You cannot measure, what you cannot control"
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
Explain operation of Haskel pump.
why we r opening HOT BYPASS valve during startup of a compressor?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
what are the use of belew gear in general ??
What are different types of orifice plates? State their uses.
how do we commission inergen system?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Name different parts of a pressure gauge.
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
how to measure oxygen which methods are using?
what is instrument philosophy
can we create an interrupt in plc through scada?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
plz send me general of ongc
