what is the jacking oil pressure of each bearing of steam
turbine?
Answer Posted / raja
Jacking oil pressure: it will help to lift the shaft to
avoid the shaft bending and easily rotate the shaft in
600MW unit jacking oil pressure is 17 to 19 Mpa
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
At 50 Centigrade (Diesel oil) what is its cast?
How to recommend which type of coupling is suitable in particular area
What is the difference between shear center flexural center of twist and elastic center?
While normal carburising and nitriding surface treatments increase fatigue strength, excessive treatment may decrease the fatigue strength. Why ?
How much resistance is offered to heat flow by drop wise condensation ?
different between general arc welding & aluminium welding?
Which pump is more efficient centrifugal pump or reciprocating pump?
Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?
What color are thermal oil piping lines?
i have want jindalsteel tecnical wrritten test paper.
What causes cylinder liner-wear down?
Dear sir, I have applied section engineer post at rrb Chennai.Please send me the previous technical question papers and answers
What parameters to be reported when we send lubricating oil for shore analysis?
what is the minimum velocity of cooling water for maximum efficiency of condensor.
Purpose of evaporator in refrigeration system.