Answer Posted / abhishek goyal
Its related to short circuit current because of that when we
design any plant and there electrical system. design
engg.(first calculate the total load)calculate the max SC
current according to that equipment will be select. Its
called the fault level:
it divided into 2 (Major):
low fault level (for normal equipment)
high fault level (for critical equipment)
as per total load of plant or capacity.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to test the Secure Elite 440 Multi function meter working condition.
why the neutral point in connnection oscillates?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
On what principle electric motor works?
Explain the difference between verilog task and verilog function?
what is the need of starter in tube light and what type of starter is used in that?
What is mean by hot and cold loop testing?
At what speed 1 HP motor can run an electric car of weighing 400 kg?
Draw the DOL starter and star delta starter drawing?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
in shunt clippers why a resistor is used in sereis with the input
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is the type of earth fault protection used in battery? explain.
what is difference between bus coupler and auto transfer switch
How to calculate cable size by using load.?? Any formula...