Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhaskar
M25:-(1:1:2)
M20:-(1:1.5:3)
M15:-(1:2:4)
M10:-(1:3:6)
M7.5:-(1:4:8)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much sand and cement requirement for 1 SQM 125mm thickness Brickwork
What are the types of slump?
How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.
types of laps in column
how we calculate the grade of the Bituminous materials.?????
if we know load bearing capacity of the soil and building load falling in each footing, then how to choose the type of foundation??? and if it is shallow foundation then which type of shallow foundation should be choosen i.e either strip or isolated or raft or combined or cantilever footing???????
What is the diff b/w ROAD TUNNEL & RAILWAY TUNNEL ??
What is thumb rule for deep trench excavation
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
If u want ur Ans.Of any Question so mail me skatiyar011@yahoo.in
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
What are the techniques to measure road difference?
how to find quantity of concrete in PCC M15
Forces in a Shear Wall are in plane or out of plane ?
How is the strength of cement measured?
