Interested to Buy Any Domain ? << Click Here >> for more details...
Is only insulation the difference between High voltage and Medium voltage cable?
- 1 Answers
- 3624 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit2009786
No material used and no of wires bounded in cable , area of cross section also differs
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the prinsiple of dc motor and construction and working ,application of dc motor.
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
What is a Phase shift meter? Where can I get one?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
How would you calculate power loss in a resistor?
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
What is the fault or needs to be done when frequency in ac drives is not changing?
Circuit diagram of tube light without starter using electrical choke
tell me about roaster switch .& what is the function in transmission & distribution?
What is servo motor and what are the applications of servo motor?
