if two transformers are parallel & both have fault short
ckt. impedance of 50KA in each case will it increase or
decrease show example?
Answer Posted / rk
it will definitely increase about 65% as in parallel i.e :-
1/R=1/R1+1/R2.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
How to back charge the Gas turbine generator
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
How to calculate the size of earth cable to earth the neutral of UPS ?
Why we use circular(Stepped) cross section in transformer core?
what is the sludge current
What is the relation between frequency and motor rpm?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
How phase to phase voltage comes 440V.
how the phase convertor changes the no. of phases
Is it possible to measure the voltage of a battery from a single terminal?
What is the maximum and minimum rating of UPS?