Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kamyar
Dedicated earthing system which is related to sensitive instrument and electronic is known as clean earth system. Althogh for many years engineers by advising standards separate clean earth from dirty (power) earth but nowadays it should be connected togrther at least in one point. The reason is "bonding".
| Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
what is diff. between earthing grid,earthing mess, earting grid?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
What is an Air COmpressor
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
300m long and 30kw inductive loade 3phase supply how many size cable required
what is mean by PIR in circuitbreaker and give me detail of that?
what is doid
What is meaning of out of phase (making & breaking) capacity And how to calculate
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What is the importance of earthing?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
