Interested to Buy Any Domain ? << Click Here >> for more details...
what is the specific application of PLC in communications,
control systems and automation?
- 2 Answers
- 7300 Views
- Idea, TCS, I also Faced
- E-Mail Answers
Answer Posted / kamal parmar
PLC is stand for Programmable Logic Control.
so its a required for a automation control of any system.
its a required for a many reason as below explain:
1) Less Men power
2) Increase accuracy of productivity
etc.
so PLC is application in automation system or communication
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
Hi Friends pls give information regarding BARC written test. am attending written exam on 1st September 2009.mail me on sanjaykm1982@indiatimes.com/sanjaykumar.b.mathur@relianceada .com
Define resolution of a data converter.
What is tunnel diode?
Explain zener breakdown and avalanche breakdown?
What do you understand by leds? How do they work?
What is the difference between power diode and signal diode?
Describe the purpose of knee point voltage for differential protection.
How many maximum PWSA cards can be inserted in a Ultra BTS cabinet How many maximum PWSB cards can be inserted in a Ultra BTS cabinet How many maximum PWSC cards can be inserted in a Ultra BTS cabinet What is the output power rating of one PWSA card What is the output power rating of one PWSB card What is the output power rating of one PWSC card What is the function of Receiver Multicoupler (M2xA or M6xA) How many TRX's are supported by one Receiver Multicoupler- M2xA How many TRX's are supported by one Receiver Multicoupler- M6xA What is the function of Remote Tune Combiner (RTxx) unit The FIU19(E) units main LED is red. What is the meaning?
What are the advantages of sequence control of ac voltage regulators?
y neutal is required for 3 phase. neutral carrys only current or voltage. in 3 phase circuits.
What is colour of flame if the of Halide Torch detects a refrigerant leakage?
A channel has a bit rate of 4kbps and a propagation delay of 20msec. For what range of frame sizes does stop-and-wait give an efficiency of at least 50%
what is transformer utilisation factor?
What is the main differnce between the SCADA and HMI also what is DCS?
Define input offset current.
