Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the minimum diameter of chairs in renforced
concrete slab or raft roundation?
- 5 Answers
- 15402 Views
- I also Faced
- E-Mail Answers
Answer Posted / hanamareddy
Dia of bar wil be
depend on depth of
raft or slab depth i.e
should be min dia of
bar used in slab
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Please tell me Detail cost of providing& laying nominal mix design 1:2.5:5,40mm nominal size.curing complete e/c cost of form work in foundation and plinth i/c carriage.
construction workers how much time take one work or qty
how many mason and labaur work for a 1 brass bricks plz let me know the calculate & how to made calculation for this and whats the formulas for this?
What is the per cu. mt. price of ready mix in Gujarat region.?
What is the cost of formwork for columns/beams/rcc walls also what is the cost of shuttering for roof slab at height of 25 feet
2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
Why steel rods are produced only in even dimensions?
what discoveries did you have in relation to your course?
how to calculate the concrete mix m30 by volume
how to calculate Rate of analysis for 100 m3 Any ratio of concrete ? including labour
in one SQM plaster how much Cement and sand consumed in ratio 1:4
04. a. Slenderness ratio…………… 1 b. If the height of a stage is 15-0 & dia. of the prop is 5, the slenderness ratio is….… 1 c. If the height of a stage is 10-0 & dia of prop is 3, the number of bracing will be…… 1
What is the difference between tor steel and tmt steel?
