what is the diference between base speed and rated speed in
motor
- 1 Answers
- 4727 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / abhishek
rated speed means the speed at full load and base speed means
the speed in normal condition
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in 132kv substation CRT means
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
star delta starter contorl circuit... drawing..
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
What are the reasons for the parallel operation of transformers?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
Post possible questions for Power Factor Panel FAT / SAT
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
Compare jfet’s and mosfet’s.
what is the difference between switch yard to residential area.and how much required it.
What is the technical difference between On delay timer and a Star delta timer?
