Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jaydev
The unit of cable IR is ohms.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the relative size of single and three phase?
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
how electrical earthing maintenance done in industry?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is the Current equation in series RLC circuits.
Draw a SLD of HT distribution EB grid up to users Transformer?
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
primery try cell?
What is the difference between indoor and outdoor transformer
How are load losses and no-load losses measured at site in a DG set?
