Interested to Buy Any Domain ? << Click Here >> for more details...
1ampear me kitna watts hota hai aur elcb ka pura naam kya hai
- 18 Answers
- 164974 Views
- Al Khayyat, Alpha G, BEC, Bhel, CGS, Electrical, Fiem, Firmenich, HLG Habtoor Leighton Group, Jash, Kandia, Maruti Suzuki, Minda, NTPC, ONEIC, Pace Process Controls, SMTC, SR, Sunrise Electrical, Sushil Enterprises, Suzlon, Voltage, I also Faced
- E-Mail Answers
Answer Posted / kesavan b
ELCB - Earth Leakage Circuit Breaker
It will trips if any leakage in the elctric circuit
Current will depends upon which system you are using usually single or three phase
formula
Watts = VI Cos (Phi)
Watts = 1.732 * VI ( COS (phi) )
| Is This Answer Correct ? | 489 Yes | 94 No |
Post New Answer View All Answers
what is difference between bus coupler and auto transfer switch
we specify current in case of feeder but in case of distributor voltage, why?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
What is I to C?
explain the functions of main isolation switches
are there rmu for 3 transformer?
In a single how much maximum current and watts using
Describe Non I.S. Earth System and why is it used?
What are the effects of adding a zero to a system?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how we can calculate chiller required ampear?
