For 6600/433 distribution transformer we apply secondary
side 433 volts how much voltage in primary side.
Answer Posted / nidal
TIS WILL QUIDE ME TO ANOTHER Q.
Can WE use a step down transformer as step up transformer
by reversing the primary voltage as a secondary voltage?
THE ANSWER IS YES WE CAN. BUT CARE SHOULD BE TAKEN FOR THE
NEW SECONDARY ( OLD PRIMARY ) AMPER NOT TO EXCEED THE
NORMAL RATING CURRENT.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
why different series of vfds (like allenbradley)are used in industry ?
can we use trip light with bus coupler?
Difference between ac parallel circuit and ac series circuit?
Name two low frequency oscillators?
What is advantages of VSCF wind electrical system?
what is meant by skew width in machines?
how to find the multiplication factor for digital energy meter and analog energy meter
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
how to calculate energy of 3-phase motor?
Describe Non I.S. Earth System and why is it used?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How does the slip regulator works as a startor
how calculate the electrical load for industry and office
Explain cos(theta) and Sin(theta)