Answer Posted / satya.mvvs

it depends on dia, angle of bends and elongation of bar.

Generally it can be calculated as

Effective Length (L) of Bar - No of bends x 2d or 3d

For 45 degrees angle it may considered as 2d and
for 90 Degrees it may considered as 3d

In practically it may be applicable to higher dia bars only
(Above 12mm)

Process of pcc in wateredug

2329

---

Analyze the rate for 1st class brick work in superstructure with 1:6 cement sand mortar. Consider 1000 cu.ft quantity and work out the rate per cu.ft

1926

---

All aptitude question of Bechtel

1939

---

In the roof of a pumping station explain briefly the components of a waterproofing system?

1219

---

In how many types u can do POP on ceiling and walls(on which material or by using which material)? b) what is the difference between dry , oil bound, enamel, acrlyic type of painting?

2371

---

use ofr concrete as per grade ?

2140

---

how to calculate cost of raw materials of a building for 1000 sqft & also consolidated cost of labour in a 1000 sqft building

2912

---

How u can calculate the Octagon ring distance from center of raft in 275 mtr chimney slipform errection? cantact no:0993455097

2330

---

What difference comes in constructing of house and a housing complex like society

1944

---

Is there any course for billing available in Mumbai? If yes then please mail me the details..

2294

---

how can calculate the compressive strength of concrete cylinder by water cement ratio ?

1752

---

What is demising walls?

1220

---

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

2196

---

why top layer of block work shoud be full size if any cut block adjustable than another layer?

2258

---

What type of tensile strength is handling by crank in beam? Thanks.

2574

---