Answer Posted / misbauddin mohammed
There are three stages in concrete's life that need to be
considered when developing the mix: the fresh concrete, the
newly completed concrete, and everything after that for the
rest of its life. The requirements for good performance in
each of these three stages can actually conflict.so we need
to design the concrete acoording to strength reqired for
all the three stages of concrete.
| Is This Answer Correct ? | 11 Yes | 10 No |
Post New Answer View All Answers
Tell me about triple point of water.
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
What are the advantages of cad software’s?
if we know load bearing capacity of the soil and building load falling in each footing, then how to choose the type of foundation??? and if it is shallow foundation then which type of shallow foundation should be choosen i.e either strip or isolated or raft or combined or cantilever footing???????
how to control PQI (Project Quality Index)
what is pile and deam foundation
what is difference between GTS bench mark and temporary bench mark
How much cement and sand are required for 1 square feet of plaster at a thickness of 15 mm at a ratio of 1:4?
What are moment of inertia and its importance in civil engineering?
What is min thickness,min grade of conc & age of PQC ?
Which percentage of carpet area use in plot area of office building.
why development length = 50D . why not 100D
Types of column foundation and how to calculate its steel quantity.
what is right & short method of measurement of slab&beam
