For 6600/433 distribution transformer we apply secondary
side 433 volts how much voltage in primary side.
- 2 Answers
- 4007 Views
- I also Faced
- E-Mail Answers
Answer Posted / gvsubbarao
If is really 6600/433 transformer,definetly it will show 6600
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Lt motor sfu flashing reasons?
What do you mean by dependent and independent voltage sources?
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
I completed iti in2004 I was worked in A grade contractor can I get c licence
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what a function diesel generetaor turbo charger & turbo charger is more heated explain reason ?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
How shall i select the value of capacitor or inductor in a system?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
If you have an earth with pilecap then your resistance is really low. why and how?
