Answer Posted / jigar soni
AS PER I.S CODE MAXIMUM SILT CONTENT SHOULD NOT BE MORE THAN 8%.
BUT AS PER THE SITE CONDITION WE CAN ALLOW SILT CONTENT UP
TO 12-14%.
CEMENT CONSUMPTION WILL INCREASE BY THAT MUCH %.
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the significance of cost estimate knowledge for an architect?
how to control PQI (Project Quality Index)
which red: used in roof teping, then use only cement
What are the different softwares used for cad?
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
what is Brest Wall?
Explain what is alternate bid?
What is braced excavation all about?
What are the different approaches in designing the floors of the service reservoirs?
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
roll of DLC in road constructions
1)What is the total volume of aggregates required for 1cu.mtr.solid hard concrete? 2)What is total mass of wet concrte and dry concrete after 28 days of M25? 3) Is 28 days strength is the final strength of concrete or it gets increasing as the time period increses.? 4)What is the volumetric proportion of concrete grade of M25.M30,M35,M40
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
what is the list of building construction equipment & teir output?
Explain what is structural frames or systems?