Answer Posted / mahendran
the ratio between real power to apparent power
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is RFID? thire application;
What is meant by time harmonics and space harmonics?
What are the advantages and disadvantages of open loop control system?
defination of transistor controlled series capacitor
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
please explain to me how to calculate current,voltage,resistance with formula??
hr round
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
what are all types of cross section in AC cables?
State ohm’s law?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
BSNL TTA EXAM QUESTION
Why AC current leads voltage in capacitor and how?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?