Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthik
Overcurrent fault mainly occurs due to the greater demand
of power either by loads or short circuit.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
when elecromagnatic waves are propogated in a wave guide?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
Where is servomechanism used?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
how to calculate differential current when we testing differential relay..suppose we have 1000kw generator,630amp VCB,what value we should put /inject so that relay trip the VCB? PLLZ justify ur comment
What is current divider rule (cdr)?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
How we can come to know the substation range,without go through any name plate ?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
wht is embedded systems? what is new inthis field?
