Interested to Buy Any Domain ? << Click Here >> for more details...
cable selection formulas for electrical load.
- 1 Answers
- 8102 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / engineered
Factors for selection of cable
1.Rated current
2.voltage drop across cable
3.derating factor based on temprature,no. of cables laid
through same path influencing each other
4. Type of laying method:- like air, ground, duct, tray,
raceway
5. type of conductor required.
6. type of insulation, like PVC, XLPE, FRLS based on site
condition
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is mind in cable
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
Is RTCC panel needs any control supply.
What is knee point voltage?
how to setting voltage RTCC panel
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
what parameters should we check to reduce the power bill
Alternator rotor earth fault relay circuit
what is effect of length of air gap on performance of dc motor and generator?
What is mean by hot and cold loop testing?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Why two phase welding machine is used instead of three phase welding machine.
STATE USE OF ARC RUNNERS & SPLITTERS ?
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
What type of fittings and electrical accessories can be install in radiation area ?
