Interested to Buy Any Domain ? << Click Here >> for more details...
what is the principle of ultrasonic flowmwter and radar type
flowmeter?
- 4 Answers
- 14284 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohammad rizwan
its work on sonar principal...
the working principal is.when the ultrasonic wave transmit from the transmitter.its travel down the surface.and reflect back to the transmitter receiver...and calculate the time taken...
it is also called TDR(TIME DOMAIN REFLECTOMETRY)system...
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
why using negative supply for bentley nevada vibration system ?
What is Cavitation in a control valve?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What is the start up procedure of desalter
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
TEMPERATURE VARIATION FOR FREQUENTLY.
With N nodes and B branches what will have a network ???
What is 3 element control system
how to relay switch sense the fault?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what is cold loop? difference between hot and cold loop?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Why ac supply load cell is used? Can we use the dc supply load cell?
what is diffrance between FF & SMART, explain with difination
