what is difference b/w HT & LT and the range of HT & LT ?
Answer Posted / hardik patel
nothing more diff but, as per voltage level we divide the
voltage level in diff-diff part.
LV-LOW VOLTAGE-UP TO 750V
MV-MIDIUM VOLTAGE-750-3.3KV
HV-HIGH VOLTAGE-3.3 TO 33KV
EHV-EXTRA HIGH VOLTAGE-MORE THEN 33 KV
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
How many types of faults are there in 3 phase power system?
What is the formuala to calculate the rating of motor protection circuit breaker
Pls explan the OLR setting in VCB at HT yard
what is servo motor and how it works?
why ahould you show client/engineer activities clearly on the project plan
what is upper impedance and lower impedance of a distance relay
what is meant by impulse voltage?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
High speed earth switch operation with diagram
Explain how to determine capacitor tolerance codes?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?