Answer Posted / sami
which power to get the Generator is called (KVA) otherwise
which power is using is called(KW)
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Define the three phase formula fuse.
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
how the B-H loop obtain under the static condition
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
is IS says that neutral should be brought to switch box. and this one is a recomended practice
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
can i connect wavetrap in 2 different phase in EHV line?
What is the phase relationship between the primary and secondary voltages of a transformer?
STATE USE OF ARC RUNNERS & SPLITTERS ?
What is meant by sag?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
What is ST and specify its range of voltage.