Interested to Buy Any Domain ? << Click Here >> for more details...
y v r connecting 250 ohms resistor in series when u
cummunicate with BT in bench calibration?
- 5 Answers
- 8237 Views
- I also Faced
- E-Mail Answers
Answer Posted / mathew thomas elenjickal
It is given so as to compensate the resistance drop in
field. When connected for calibration wires of shorter
legth are connected , so no drop in resistance occours.
The instrument is designed in a way to compensate field
resistance loss.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
protection relay watchdog contact operation?
Explain bernoulli’s theorem.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
How the sizing of the analog signal cable is calculate?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
What is hp & mp seperator .& what is its working principle ?
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
Calibration procedure for Electro magnetic Flow meter
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
it is possible to check the fail safe condition in pressure transmitter. if possible how?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is frequency factor in massflow meter? When using frequency output?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Explain PID, ON/OFF, Controls
How to work togather like sov,limit switch,proxy switch and booster in xv
