Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of starter & choke in the tube light
set & how choke give 1000 volts while switching on.
- 14 Answers
- 86823 Views
- ADNOC Abu Dhabi National Oil Company, IBM, I also Faced
- E-Mail Answers
Answer Posted / vinod yadav
gases present in the tube light is of such nature that once the gas ionised then it has a tendency to increase continuously accompanied by a fall in the circuit resistance . in order to limit the current to a safe value choke is used .
choke performs two function
1) providing ignition voltage
2) limiting the current
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
What are the electrical engineer roles and responsibilities in chemical plant?
How to calculate Ith (I thermal) for curent transformer
In CTs tan delta point should be earthed , what is the reason behind it?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
How would you relate your key competencies to this position?
what will happen if frequency is below 50 hz?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
What is expention fastener (Fan)
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
How to calculate impedance volt in Transformer?
oil cooled transformer
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
