Interested to Buy Any Domain ? << Click Here >> for more details...
y v r connecting 250 ohms resistor in series when u
cummunicate with BT in bench calibration?
- 5 Answers
- 8636 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhu
because it raise the stenghth of a signal
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
What is offset in a control system.
Why plc require in analog input 4-20amp & 0-10 volt?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
What is the principle of capacitance type level transmitter?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
what is RTV function in in process control?
How to fix back the valve actuator stem
Linear amplifier.
How can a d.p. Transmitter be calibrated?
What is eddy current? Describe the operating principle of proximity probe.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
