Can I use 1 phase power supply to run 3 phase motor? If yes, how?
Answer Posted / snk
fix a capacitor in between two winding that will split the
phase angle difference of angle will produce rotating field
and motor will start moving.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
please send me the L&T Emb. sys. placement papers and entire details of pattren
how to find impedance , mutual indatnce in transmission lines
What is the difference between Delta & Wye windings?
distribution is maximum done by a)radial b)network c) parallel d)b & c
how to calculate singlephase motor efficiency?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
What is a commutator?
what is vA rating and class of a ct.
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
how many single tension hardware are required on a double circuit transmission tower?
What is the drawback of class b amplifier? How is this minimized?