Interested to Buy Any Domain ? << Click Here >> for more details...
why most of the DP transmitters using maximum range as
0-2500mmwc?why not 1000 2000 3000 4000mmwc
- 2 Answers
- 8437 Views
- SPIC, TNPL, I also Faced
- E-Mail Answers
Answer Posted / akhil
it is the standard and highest range for capsule of the
transmitter.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
What is limitation of the ht.of the displacer of a level trol?
State some of balance principle’ advantages?
the output of the common trasmitter protocol in qatar gas are the following
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
how to commission furnace ( water heater)
What is 3 element control system
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
If fire would be inside the plant which fire detector is to detected the fire.
Capacitance, resistance ( colour coding ), parallel & series circuits.
whatis range of marcury filled tempereture gague
Why ac supply load cell is used? Can we use the dc supply load cell?
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
What are the types of valves?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
