Interested to Buy Any Domain ? << Click Here >> for more details...
in DCS or PLC we can not put all ai or di,there is
calculation through which we can accomodate certain no of
digital and analog signal.I need to know that calculation
- 1 Answers
- 4608 Views
- I also Faced
- E-Mail Answers
Answer Posted / mithilesh kumar
Hi friend,
No any caculation for total ai,ao,do,do
Which is present in dcs,plc.
It's depends upon how much I/o's require
For this project.
You can calculate no of I/Os with help of
Present module/card.
Any other answer you most welcome.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is offset in a control system.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Emergency Shutdown Systems/ Plant Shutdown System.
key exchanges in wpa,wpa2,tls
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What are different types of valves?
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
Manipulation of dead wt. tester double piston type.
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
What is 3 selection available when configure the burnout protection for controller
What is super thermocoupal?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
what is cems analyzer explain with principle and drawing ?
Reason for capillary type dp level transmitter fluctuation
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
