What will happen when we connect 2 bulbs in series between 2
phases
Answer Posted / shri..
Nothing will happen if we are selecting the lamp
100W, 240V X 2 = 280Volt
PN Volt 240X2 = 480 Volt
Both will glow
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
what is ground fault in ACB?
what is is the potential diffrence between two phase ?
what is the isolation transformer. what is the isolator?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
Can you explain about pole discrepancy scheme
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How cmd is calculated in case of energy neters
what is meant by re-rolling motor? how it differs from standard motor?
What is the difference between vector surge relay (78) and Pole slip relay (98G)
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
how to check avr of dg set of 125kva
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What are the classifications of oscillators?