Interested to Buy Any Domain ? << Click Here >> for more details...
In Panels Main Incomer considered should be TPN or FP?
- 2 Answers
- 5244 Views
- I also Faced
- E-Mail Answers
Answer Posted / muthuvel
If it is interlocked with DG side It Should 4P otherwise it can be TPN
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what are the parameters plays a major role in Potential transformer Burden calculation??
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
What is the difference between circuit breaker and isolator
Why front mounted CT polarities are always towards breaker?
Why do we require transformer with less specific weight if supply frequency is increased?
What is oscillator circuit?
What is the relationship between voltage,current & frequency?
Explain marx circuit.
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is stepper motor?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
Difference between ac parallel circuit and ac series circuit?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
