hi, is there a difference in choosing bus bar for DC or AC
,,if there can anyone help me about.
thanks
Answer Posted / vinayak
the dimension, type and material of the bus bar conductor
depends upon the capacity of the conductor or the current
intake.
long story short whether it is a dc or ac busbar it is same
for the same capacity
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why the arms of delta in a delta-wye power transmission system are kept constant??
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
how to generator maintenance (A Check, B check,Etc)
What are the different types of controllers?
State the frequency for rc phase shift oscillator?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
How test for Ddo vector group test condition?
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
What are the three types of compensators?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
please explain how to do 'pole drop test' on generator?
how can see the ac indoor or out door ac which Tr