If I want to lab 16 mm dia. bar with 20 mm dia bar with 40D
lap length which dia.should I consider for lapping
Answer Posted / muzammil khan
lap lenghth of smaller dia should be always consider.
16mm dia.
Is This Answer Correct ? | 23 Yes | 3 No |
Post New Answer View All Answers
What is the wall thickness of NP-3&NP-4 hume pipe as per I.S code
How is the leaning tower of pisa supported?
how to estimate material requirement for an area of house in square feet?
Define Workability ?
do you think we shall remove un wanted soil for foundation excavation even if the thickness of the soil strata is more than 8m ?
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
what is column foundation
How long does it take concrete to harden?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
Define What is Civil Engineering?
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
What is the crank length in the slab?
What should be the maximum allowable time for placing ready mix concrete? The specification requires concrete placement within 90 minutes of batching at the plant. What is the significance of this 90 minutes & should this be used as a rejection criterion? What effects does the concrete has after that time period?
what is mean by reestimation?
What is thumb rule in quality and quantity estimation of a Residential building??