Interested to Buy Any Domain ? << Click Here >> for more details...
what is the problem in manufacturing transformer with 0
degree phase displacement.???why alwasys go for DYn11 or
DY5?Whys not DY0 i.e zero degree displacement between
primary and secondary side vectors?
- 3 Answers
- 7713 Views
- Bhel, dpdc, Prime Electrical, I also Faced
- E-Mail Answers
Post New Answer View All Answers
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
Why induction motor is widely used in industry
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
What is self exciting?
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
what is the Transformer Impedence?How can calculate?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
What is turn ratio of a transformer?
Define cut-off rate?
SUTIABLE FOR ohm's law super conductor
