Interested to Buy Any Domain ? << Click Here >> for more details...
which type of shaft is preferred for power transmission,
solid or hollow one?
- 5 Answers
- 15738 Views
- I also Faced
- E-Mail Answers
Answer Posted / pramendra vishwakarma
hollow shaft is preferred for high load power transmission
because it has higher moment of inertia than solid shaft.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
what is the type filter in clean side in ge 9 fa gas turbine ?
Why the work per kg of air flow in axial flow compressor is less compared to centrifugal compressor for same pressure ratio ?
what is draft and draft loss?in a boiler,how is draft created?
please send me previous placement papers of cummins company
Why pert is preferred over cpm for evaluation of project ?
Action plan to closr NCR (NON COONFORMANCE REPORTS)
What is meant by indirect contact heat exchanger?
When we are calculating the heat load sheets,why we are not considering the heat developed from the blood in the human body.Also both men & women can't acess aircondition in same way..women feel too cool even at 22 degree,while men can overcome that.
relate the frequency between feed water treatment & blow off
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
what is jdbc bridge?
Why do you need a biological shield in nuclear plants?
Sir we wants to const ruct a wall,size wall is 50x30x9/12' feet.how many bricks required. Please advise
efficiency of diesel generator set:kwh x 3410 x 100/ fuel in ltrs x 0.87 x 2.2 x 19000. is it correct formula
I need BHEL apptitude questions
