Interested to Buy Any Domain ? << Click Here >> for more details...
what is cogging and crawling
- 20 Answers
- 85179 Views
- ABB, Ashok Leyland, Bharat Bijlee, BMRCL, MN Dastur, Siemens, I also Faced
- E-Mail Answers
Answer Posted / kiran
if the no. of stator poles are been equal to the no. of
rotor poles in an induction motor then the machine refuses
to start. then that reason is called as cogging.this is due
to the failure of machine elements(i.e,bearings) of an
electrical machine.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
single phase power supply give to separate one steel coup with water, what reaction create
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
What is the formulae of Megger value for a A.C.Motor
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
How can find thermal state value in relay for calculate thermal overload.
why do we lay up the core of a cable?
How cable from Kit-Kat to main switch, from starter to motor are designed?
Why is water motor not taking the pressure? what is the problem?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
what is the differance between HT motors And LT MOTORS.
what transformer we used normally and upto which kva?
If increased the frequency up to 1000 then what changes shows in voltage?
what is interpose? where it is used and why it is used?
