Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / laxmikanta sasmal
this is depend on load data,distance from source,laying method
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Purpose of providing neutral isolation panel for parallel operation of diesel generator
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
do we use links in a dc circuit?if so what s its use in it?
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
Define rise time.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
How to calculate cable size in HT AND LT
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
explain different losses in a transformer.
