Answer Posted / ashok mishra
large and interconnected
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In CTs tan delta point should be earthed , what is the reason behind it?
what are the disadvantages in GIS over AIS
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
in dc series motor if field wdg is shorted then
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is inrush current?
Why efficiency in thermal power plant is low?
Explain about 3 phase motor fault current calculation with examples?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
why we are using earth pit in sub stations.?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
harmonics filter
If a high resistance fault occurs,then what are the changes will happen in the system?