what will happen if capacitor bank is used in generation side?
Answer Posted / antaratara ghosh
the reasons are:
1. Capacitors will absorb harmonics as their impedance
decreases and frequency increases, resulting in overheating
and increased stress that leads towards premature failure
2. Capacitors will resonate with the system impedance,
causing high voltage spikes and current upto 10 times the
normal level.
3. Switching of capacitor banks creates voltage transients
resulting overvoltage to loads and can damage solid state
equipments like variable frequency drives.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
For a stable system, where should the poles of a system be in a root loci plot?
please send me the L&T Emb. sys. placement papers and entire details of pattren
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Operation carried out in thermal power stations?
How phase to phase voltage comes 440V.
How much of the total hydro power potential has been exploited so far in india?
What are the advantages and disadvantages of open loop control system?
what is the clear formula to calculate cable size for a load
what is the mechanical safety of DG ?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?