PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
Answer Posted / nisha rani
give me solved question paper in AE E&M
Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
how to calculate percentage impedence at 75 deg C at normal tap
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
what is the purpose of silicon dropper used in battery charger?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What can you contribute to the progress of our Company as an employee if you are selected?
How to measure the earth resistance value in a concrete pavement(flood light area)?
sir iam a 3rd yr eee student.no core company comes for recruitment to our college.my aim is to be placed in l and t.tell me the procedures.
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
can i connect the two phases of scott connected transformer,if not why?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is the difference between general inverter and solor inverter clerly explain plz
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
why ct ,cvt should be stored in a vertical position?