Interested to Buy Any Domain ? << Click Here >> for more details...
what is orifice plate?
Give me best answer?....plz
- 5 Answers
- 11391 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul nayak
orifice plate is used in liquid flow lines to measure the
flow rate by creating a differential pressure across it,
which is than converted in to flow rates by means of some
circuits. in some cases it is also used to reduce the
pressure in line.
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
Explain why plc require in analog input 4-20amp & 0-10 volt?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
If P will increase then what will happen with PID?
why I need valve guard and whats different between guard and positioner ??
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
how many type conductivity sensor ?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
