Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead tank CT AND what is live tank CT
- 2 Answers
- 7975 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
In case of live tank, the metal tank of the oil is connected
to supply.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
why constant voltage transformer should be start without load? and if started then what will happen?
What is the relationship between voltage,current & frequency?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
i want to model paper for section engg.
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
12.5 tons a/c is their how much kva generator can recommend to the customer.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
how is working bearing heater?
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
Zone of protection and tripping scheme of arc protection relay.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
THERMAL CAPACITANCE IS MEASURED IN..................................................
What is the difference between a 3 winding and 2 winding Potential Transformer
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
