MCCB 400 Amps 50KA 430Volt AC
What is mean by 50KA
- 16 Answers
- 50726 Views
- I also Faced
- E-Mail Answers
Answer Posted / sagir
50kA means the fault current carrying capacity of said MCCB is up to 50000Amps. Above this rating the MCCB goes trip or damage. The protection capacity is 50,000Amps.
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
Pl.brief me any electrical major fault you have rectified.
which capacity of RCCB used for five thousand watt electricity load?
How is the speed of a DC shunt motor related to the armature current?
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
Define step response?
how to do the ductor test?
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how can we calculate the ratio of caustic soda and water in lrs.
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
how can you calculate fault level ?
